/* USB OTG (On The Go) defines */ /* * * These APIs may be used between USB controllers. USB device drivers * (for either host or peripheral roles) don't use these calls; they * continue to use just usb_device and usb_gadget. */ #ifndef __LINUX_USB_OTG_H #define __LINUX_USB_OTG_H #include /* OTG defines lots of enumeration states before device reset */ enum usb_otg_state { OTG_STATE_UNDEFINED = 0, /* single-role peripheral, and dual-role default-b */ OTG_STATE_B_IDLE, OTG_STATE_B_SRP_INIT, OTG_STATE_B_PERIPHERAL, /* extra dual-role default-b states */ OTG_STATE_B_WAIT_ACON, OTG_STATE_B_HOST, /* dual-role default-a */ OTG_STATE_A_IDLE, OTG_STATE_A_WAIT_VRISE, OTG_STATE_A_WAIT_BCON, OTG_STATE_A_HOST, OTG_STATE_A_SUSPEND, OTG_STATE_A_PERIPHERAL, OTG_STATE_A_WAIT_VFALL, OTG_STATE_A_VBUS_ERR, }; enum usb_xceiv_events { USB_EVENT_NONE, /* no events or cable disconnected */ USB_EVENT_VBUS, /* vbus valid event */ USB_EVENT_ID, /* id was grounded */ USB_EVENT_CHARGER, /* usb dedicated charger */ USB_EVENT_ENUMERATED, /* gadget driver enumerated */ }; struct otg_transceiver; /* for transceivers connected thru an ULPI interface, the user must * provide access ops */ struct otg_io_access_ops { int (*read)(struct otg_transceiver *otg, u32 reg); int (*write)(struct otg_transceiver *otg, u32 val, u32 reg); }; /* * the otg driver needs to interact with both device side and host side * usb controllers. it decides which controller is active at a given * moment, using the transceiver, ID signal, HNP and sometimes static * configuration information (including "board isn't wired for otg"). */ struct otg_transceiver { struct device *dev; const char *label; unsigned int flags; u8 id; u8 default_a; enum usb_otg_state state; enum usb_xceiv_events last_event; struct usb_bus *host; struct usb_gadget *gadget; struct otg_io_access_ops *io_ops; void __iomem *io_priv; /* for notification of usb_xceiv_events */ struct atomic_notifier_head notifier; /* to pass extra port status to the root hub */ u16 port_status; u16 port_change; /* initialize/shutdown the OTG controller */ int (*init)(struct otg_transceiver *otg); void (*shutdown)(struct otg_transceiver *otg); /* bind/unbind the host controller */ int (*set_host)(struct otg_transceiver *otg, struct usb_bus *host); /* bind/unbind the peripheral controller */ int (*set_peripheral)(struct otg_transceiver *otg, struct usb_gadget *gadget); /* effective for B devices, ignored for A-peripheral */ int (*set_power)(struct otg_transceiver *otg, unsigned mA); /* effective for A-peripheral, ignored for B devices */ int (*set_vbus)(struct otg_transceiver *otg, bool enabled); /* for non-OTG B devices: set transceiver into suspend mode */ int (*set_suspend)(struct otg_transceiver *otg, int suspend); /* for B devices only: start session with A-Host */ int (*start_srp)(struct otg_transceiver *otg); /* start or continue HNP role switch */ int (*start_hnp)(struct otg_transceiver *otg); }; /* for board-specific init logic */ extern int otg_set_transceiver(struct otg_transceiver *); extern int otg_reset_transceiver(struct otg_transceiver *); #if defined(CONFIG_NOP_USB_XCEIV) || (defined(CONFIG_NOP_USB_XCEIV_MODULE) && defined(MODULE)) /* sometimes transceivers are accessed only through e.g. ULPI */ extern void usb_nop_xceiv_register(int id); extern void usb_nop_xceiv_unregister(int id); #else static inline void usb_nop_xceiv_register(int id) { } static inline void usb_nop_xceiv_unregister(int id) { } #endif /* helpers for direct access thru low-level io interface */ static inline int otg_io_read(struct otg_transceiver *otg, u32 reg) { if (otg->io_ops && otg->io_ops->read) return otg->io_ops->read(otg, reg); return -EINVAL; } static inline int otg_io_write(struct otg_transceiver *otg, u32 val, u32 reg) { if (otg->io_ops && otg->io_ops->write) return otg->io_ops->write(otg, val, reg); return -EINVAL; } static inline int otg_init(struct otg_transceiver *otg) { if (otg->init) return otg->init(otg); return 0; } static inline void otg_shutdown(struct otg_transceiver *otg) { if (otg->shutdown) otg->shutdown(otg); } /* for usb host and peripheral controller drivers */ #ifdef CONFIG_USB_OTG_UTILS extern struct otg_transceiver *otg_get_transceiver(int id); extern void otg_put_transceiver(struct otg_transceiver *); extern const char *otg_state_string(enum usb_otg_state state); #else static inline struct otg_transceiver *otg_get_transceiver(int id) { return NULL; } static inline void otg_put_transceiver(struct otg_transceiver *x) { } static inline const char *otg_state_string(enum usb_otg_state state) { return NULL; } #endif /* Context: can sleep */ static inline int otg_start_hnp(struct otg_transceiver *otg) { return otg->start_hnp(otg); } /* Context: can sleep */ static inline int otg_set_vbus(struct otg_transceiver *otg, bool enabled) { return otg->set_vbus(otg, enabled); } /* for HCDs */ static inline int otg_set_host(struct otg_transceiver *otg, struct usb_bus *host) { return otg->set_host(otg, host); } /* for usb peripheral controller drivers */ /* Context: can sleep */ static inline int otg_set_peripheral(struct otg_transceiver *otg, struct usb_gadget *periph) { return otg->set_peripheral(otg, periph); } static inline int otg_set_power(struct otg_transceiver *otg, unsigned mA) { return otg->set_power(otg, mA); } /* Context: can sleep */ static inline int otg_set_suspend(struct otg_transceiver *otg, int suspend) { if (otg->set_suspend != NULL) return otg->set_suspend(otg, suspend); else return 0; } static inline int otg_start_srp(struct otg_transceiver *otg) { return otg->start_srp(otg); } /* notifiers */ static inline int otg_register_notifier(struct otg_transceiver *otg, struct notifier_block *nb) { return atomic_notifier_chain_register(&otg->notifier, nb); } static inline void otg_unregister_notifier(struct otg_transceiver *otg, struct notifier_block *nb) { atomic_notifier_chain_unregister(&otg->notifier, nb); } /* for OTG controller drivers (and maybe other stuff) */ extern int usb_bus_start_enum(struct usb_bus *bus, unsigned port_num); #endif /* __LINUX_USB_OTG_H */